Plumbing in Las Vegas, NV
We cover the whole Las Vegas Valley, and the work changes noticeably by neighborhood. Central and older east-side homes around Huntridge and John S. Park often still have original galvanized supply or cast-iron drains that need a camera inspection before anyone starts cutting. Newer construction on the west side tends to have PEX and slab-routed supply lines, where the job is usually electronic leak detection rather than demolition. What every Valley home shares is water hardness — roughly 16 to 18 grains coming off Lake Mead, which is what scales heaters, seizes angle stops, and shortens fixture life across the entire city.
What we see most in Las Vegas
- Galvanized supply lines still in service in pre-1970 homes around Huntridge, quietly choking flow
- Cast-iron drain lines scaling and cracking in older east-side properties
- Water heaters scaling out years early on unsoftened municipal supply
- Angle stops seized solid, turning a fifteen-minute repair into a whole-house shutoff
Neighborhoods we cover
- Huntridge
- John S. Park
- Downtown
- Centennial Hills
- Rancho Oakey
ZIP codes served: 89101, 89102, 89104, 89106, 89107, 89108, 89117, 89128
Services available in Las Vegas
Emergency Plumbing
Burst pipes, major leaks, and no-water emergencies. Answered 24/7, usually on site within the hour.
Slab Leak Detection & Repair
Most Valley homes sit on a slab. We locate the leak electronically before opening any concrete.
Water Heater Repair & Replacement
Hard water shortens heater life here. We flush, repair, replace, and install tankless.
Water Softeners & Whole-Home Filtration
The single best investment against Las Vegas hard water. Installed, serviced, and maintained.
From Las Vegas customers
Installed a softener and the difference in the shower alone was worth it. No more spotting on the glass, and the coffee maker stopped scaling up every three months.
Kitchen drain had backed up three times in a year with two other companies. These guys put a camera down it, found roots in the lateral, jetted it properly and showed me the footage. No problems since.